How do I apply the Bath and Toilet Nanocoat?Updated 3 months ago

IMPORTANT: Make sure the area is well-ventilated before use.

We encourage you to wear a mask, gloves, and goggles while applying the nanocoat.

STEP 1: CLEAN THE SURFACE

For Toilets: Remove all water from the bowl by turning off the water and flushing the toilet. 

For Baths: Thoroughly clean the surface with a hard water remover or toilet cleaner and brush.

STEP 2: SPRAY & WIPE

Treat 1-3m2 at a time and spray the nanocoat over the surface until it is evenly and completely covered. You should only require 2-3 sprays for this area.

Continue to work the product into the surface in a circular motion.

STEP 3: SUCCESS!

Wait 10 minutes for the coating to cure to ensure you get your full 12+ months of protection.

You can now use your bath, bathroom surfaces or toilet as normal.

If you have any further questions, our customer support team is happy to assist you. For contact information, please click here. 

https://glassguard.com.au/products/bath-toilet-nanocoat